Artist Help:Step Timing

You can assign individual fade in and a hold times to steps of a sequential scene. By default the timing for scene steps is provided by the Control Panel 'Rate' control. The steps shown in the navigator window are normally called 'Step'. If a step contains individual fade in and/or hold time then it is displayed as 'Step t1/t2". Where t1 is the fade in time and t2 is the hold time for the step.

To set timing to a step

• right-click on the step in the navigator window.
• select 'Properties'. A rate slider is displayed.
• with the box unchecked set the fade in time. This time is the whole step time.
• uncheck the box and set the percentage of the set time required to hold.
• close the window and observe the updated text for the step.

To reset default timing

• right-click on the step in the navigator window.
• select 'Properties' to display the rate fader.
• click on 'Zero'

See Rate and BPM Control.