Knowledge Base:Touch Screen: Difference between revisions
MickShowCAD (talk | contribs) (Created page with "Touch Screen by Mick Martin | Feb 24, 2012 | Knowledge Base Introduction You can use any touch screen but we supply ELOtouch screen because of our experience with them. This article is specific to ELO but others will require a similar setup process. With all applications including Artist shut down, install the drivers from the disk supplied from ELO. Often you will use the touch screen as a second monitor. If this is the case ensure you have set whether the monitor is...") |
MickShowCAD (talk | contribs) m (MickShowCAD moved page Touch Screen to Knowledge Base:Touch Screen) |
(No difference)
| |
Latest revision as of 21:32, 14 May 2024
Touch Screen by Mick Martin | Feb 24, 2012 | Knowledge Base
Introduction
You can use any touch screen but we supply ELOtouch screen because of our experience with them. This article is specific to ELO but others will require a similar setup process.
With all applications including Artist shut down, install the drivers from the disk supplied from ELO. Often you will use the touch screen as a second monitor. If this is the case ensure you have set whether the monitor is the primary or secondary – usually the secondary.
Setting up Artist
This procedure sets the Operator to automaticall open in full screen mode on a specified monitor when Atrist is launched.
Run Artist click on Operator to open the operator GUI press ‘F2’ or select Properties from the menu bar select the Display tab select the monitor from the Screen Setup combo box. click OK press ctrl-X to close the operator screen main menu/Tools/Preferences/Start Up check Operator GUI click OK Now save the workspace.