Editing Knowledge Base: ShowCAD USB-DMX

ShowCAD USB-DMX problems
by Mick Martin | Mar 19, 2012 | Knowledge Base

If you are having trouble with the ShowCAD USB interface.

Verify in Artist

This step will determin if Artist can see the interface.

Open Main Menu/Help/Log file – scroll down to the bottom of the file and find the last Log on. Scroll down further and find the line that says – ShowCAD USB–DMX. This will show how many interfaces are detected. If you interface is missing from the list, then the issue is with drivers or hardware.

Hardware Check

If the interface is receiving data from Artist the Green LED will be flashing continuously. If no data is being output the problem is either with the DMX line wiring of the interface output is faulty. It is worth lashing up a test DMX fixture to verify the interface DMX output because there can be a delay in sending a new interface. 

If this is not the case, when you plug the interface in to the USB port, the Green LED on the interface should flash once as it is powered up.

If this doesn’t happen. Try the interface on another USB port and maybe another computer to see if the LED flashes. If it does then the issue is with the PC USB port.

Windows Device Manager Check

Open Device Manager (Start/Run/Device Manager) and open Ports (COM & LPT). The interface should show up as USB serial port. Unplug the interface to see it removed from the list. If this doesn’t happen then there is an issue with the interface drivers. Re-install Artist may cure the problem.

Input Output Patch Check

If the interface is patched correctly the Green LED should be flashing continuously indicating the data is being sent to it from Artist. If this is the case and your cue still don’t function, check the Fixture addresses are set to the correct universe.


ShowCAD USB-DMX Interface
by Mick Martin | Feb 18, 2012 | Knowledge Base

This device interfaces your computer to your DMX fixtures. The output is electrically isolate and protects your computer from any high voltages that might appear on the DMX line. For this reason we only recommend these USB devices for use on Desktop systems.

A maximum of two interfaces is recommended for a trouble free installation.

In general simply installing Artist should install the drivers for this interface.

If in Navigator/Resources the interface is not found (indicated by a red asterisk on the interface icon) then go to Windows Control Panel/System/Device Manager. First look under COM ports for the interface and check under Universal Serial Bus for the Serial Converter. If either of these are missing run c:\Program files\artist\vcom_setup.exe.

You should now find that Device Manager recognises the device and now when you run Artist the red asterisk should have gone.

If the Device Manager shows an unknown device or a yellow question mark after this procedure, you should connect the system to the internet and allow it to search for the appropriate drivers.