Editing Artist Help:Step Timing

You can assign individual fade in and a hold times to steps of a sequential scene. By default the timing for scene steps is provided by the Control Panel 'Rate' control. The steps shown in the navigator window are normally called 'Step'. If a step contains individual fade in and/or hold time then it is displayed as 'Step t1/t2". Where t1 is the fade in time and t2 is the hold time for the step.

=== To set timing to a step ===
* right-click on the step in the navigator window. 
* select 'Properties'. A rate slider is displayed. 
* with the box unchecked set the fade in time. This time is the whole step time. 
* uncheck the box and set the percentage of the set time required to hold. 
* close the window and observe the updated text for the step. 

=== To reset default timing ===
* right-click on the step in the navigator window. 
* select 'Properties' to display the rate fader. 
* click on 'Zero' 

 See Rate and BPM Control.