Editing Artist Help:Offset Address

Sometimes it is necessary during installation of a lighting system to alter the DMX assignments of your fixtures. This dialog allows you offset the addresses of a group of fixtures.

* In the Fixture Navigator tree, right-click on the required fixture group. 
* Select Offset Address. 

The list shows all the fixtures within the group that you are about to alter. You can remove selected fixtures from the list by selecting them and click on Remove.

Use the combo box to change the DMX line used. If the DMX line is already correct select 'No change'.

Set the address offset value. This value can be a positive or negative value that will be added to each of the Selected Fixtures.

Click OK to set the new addresses to the selected fixtures.