Editing Artist Help:Effects Dimmer

First, load the 'EXAMPLE.WSP' workspace supplied with Artist. The first fixture group (Just 8 Par cans) is 8 x par cans. Display this group in the Fixture view. If you have Wysiwyg you can also use the 'EXAMPLE.WYG' plot to view the effects.

=== Try the example Cues ===

Open the Operator window and select 'Parcan cues' (Cue list 1) which contains cues pertaining to the par cans. The first three cues (Cue 1, Cue 2 and Cue 3) are simple static levels. Try each in turn and watch the active Fixture View to see their effect.

The fourth cue (Strobe) uses an 'Envelope' effect to create a chase with a blank between each step given it a strobing appearance.

 Cues 5 and 6 are 'Chase' effects and are not defined in the Effects window.

 Cue 7 (Wash) also uses an 'Envelope' effect to give a continuous waving effect.

=== Try the Macros ===

Deactivate any running cues and open the Effect tab in the Fixture Control window. Now you can try the effects yourself.

* Activate the 'Dimmer' parameter from the Parameter List. 

* Select the Macros tab 

* Now try each of the Linear Macros in turn while watching the results in the Fixture View. 

Each of these macros is specifically designed for fixtures arranged in one dimension.

=== Making Changes ===

These macro you have just tried simply set the Effect properties in the Properties tab to some predefined values. You can, of coarse, alter these to your requirements. 
Select the 'Chase' macro in the Linear column and click on the Properties tab.

 
  
 The monitor window show the 8 par cans levels move across the shape set by the macro. Notice the high part of the shape is wide enough to allow only one channel at a time to be 100% (the Foreground level). 
 Click on the 'Width' property button to select the Width property. Set the fixed value to about 50%. Now a block of 4 channels is chasing across the fixtures.
 
 
 Then select the 'Top' property and set it to zero. The Monitor now shows a triangular peak and a flat region after it. You will now see the par cans fading in and out.
 
 
 Set the 'Slope' property to zero. Now the channels snap on at 100% then fade to zero. 
 Now set the 'Spread' to about 40% and notice that the channel are not now spread across the whole wave but are bunched up. 
 Click on the 'Chase' macro again to reset the properties and the set the 'Foreground' to 0% and the 'Background' to 79%. Notice that you now have a dark chase with the on level at 79% 

Slow the 'Master Rate' down to see exactly what the effect now is.

Play with the properties a while to reveal the power of the 'Envelope' generator effect.